💬 midtownkc's Topics
Loose Rotor Drivers Side - 6G Celicas Forums
6th Generation Celica
› Suspension/Handling/Braking
Started: EnthusiastJoined Jun 28, '10From kansas cityCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined May 10, '10From MACurrentlyOfflineReputation:37(100%)
Hello, recently went to replace my tie rod ends...removed the wheels and found that they had no play in them at all but my driver side rotor wobbles..about 1cm of give each way...is this a wheel beari...
9 replies
Topic ID: 75365
Rear tires leaning inward at top like this --/--\ - 6G Celicas Forums
6th Generation Celica
› Suspension/Handling/Braking
Started: EnthusiastJoined Jun 28, '10From kansas cityCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Sep 29, '09From Prince George, BC CANADA EH!CurrentlyOfflineReputation:8(100%)
Will alignment fix this problem?? The tires are both slightly tilted inward towards the top..not majorly but surely enough to cause extra wear on the inner part of the tires. Just wondering if al...
10 replies
Topic ID: 74923
low idle and then low power at 4500 rpms+ - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Jun 28, '10From kansas cityCurrentlyOfflineReputation:0(0%)
Hello,
ok my 94 gt which I've recently replaced about everything aside from the tranny/clutch/fuel pump, idles normal(7-800 rpms) but sometimes drops to about 400 rpms and almost dies. It does this ...
ok my 94 gt which I've recently replaced about everything aside from the tranny/clutch/fuel pump, idles normal(7-800 rpms) but sometimes drops to about 400 rpms and almost dies. It does this ...
3 replies
Topic ID: 74888
Replacing Distributor - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Jun 28, '10From kansas cityCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Mar 28, '10From Columbia, South CarolinaCurrentlyOfflineReputation:1(100%)
Okay so i just bought a new distributor because my old one was shot(hopefully the source of all my problems) I cant seem to get the new one back flush against the block(has about 2 centimeters) my ol...
2 replies
Topic ID: 74818
Won't start, Plugs are getting fire - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Jun 28, '10From kansas cityCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Nov 16, '06From Findlay,OhCurrentlyOfflineReputation:-1(33%)
I replaced wires, plugs, distributor, rotor, fuel filter, tested the fuel pump by bridging the terminals in the diagnostic port, i heard it fine. There was no error code when i bridged the te1 and e1...
2 replies
Topic ID: 74802
Engine sputtered, finally died, would not restart - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Jun 28, '10From kansas cityCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Mar 22, '07From Houston, TXCurrentlyOfflineReputation:4(100%)
I recently replaced my plugs/wires/distributor cap and rotor because my car was stuttering at lower rpms(2500 and lower in higher gears) it was running fine for about 2 days and then started stutteri...
2 replies
Topic ID: 74782
Engine Stutter(oil on plugs) - 6G Celicas Forums
6th Generation Celica
› Engine/Transmission/Maintenance
Started: EnthusiastJoined Jun 28, '10From kansas cityCurrentlyOfflineReputation:0(0%)
I was driving my celica yesterday and it started stuttering going down the highway. I checked the distributor and rotor..both were in terrible condition so i replaced them. That did not work so i w...
4 replies
Topic ID: 74713
Showing page 1 of 1 (7 total topics started)