💬 dougone81's Topics

dougone81

📍 Grande Prairie, Canada
Member
Topics
7
Vehicles
1

Drive shaft clunking - 6G Celicas Forums

6th Generation Celica › Engine/Transmission/Maintenance
Started: EnthusiastJoined Mar 28, '10From Grande Prairie, CanadaCurrentlyOfflineReputation:0(0%)
There is a big clunking noise when I accelerate from a stop and decelerate without shifting and going from forward to reverse ect. Got underneath and it was on the stabalizer joint nearest to the rear...
2 replies Topic ID: 80135

fuel shortage?? - 6G Celicas Forums

6th Generation Celica › Engine/Transmission/Maintenance
Started: EnthusiastJoined Mar 28, '10From Grande Prairie, CanadaCurrentlyOfflineReputation:0(0%)
on my st205 when i have the throttle pinned the turbo pulls hard until 4500-5000 rpm (depending on how long the engine has been running. little higher as the engine is hotter), and then i looses power...
3 replies Topic ID: 76292

clunking sound - 6G Celicas Forums

6th Generation Celica › Suspension/Handling/Braking
Started: EnthusiastJoined Mar 28, '10From Grande Prairie, CanadaCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Mar 30, '09From JamaicaCurrentlyOfflineReputation:0(0%)
after having this clunking sound coming from my front end after hitting bumps or rough roads, i replaced the figure 8 joints. while instling them i checked all the ball joints and everything seemed we...
8 replies Topic ID: 76252

Loosing power! - 6G Celicas Forums

6th Generation Celica › Forced Induction
Started: EnthusiastJoined Mar 28, '10From Grande Prairie, CanadaCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Mar 30, '09From JamaicaCurrentlyOfflineReputation:0(0%)
i have a quiestion regarding my gtfour. When I punch the throttle, the turbo pulls hard untill 5000 RPM and then completly loses power until you let off the throttle a bit,then it will start reving hi...
7 replies Topic ID: 74937

checkengine - 6G Celicas Forums

6th Generation Celica › Engine/Transmission/Maintenance
Started: EnthusiastJoined Mar 28, '10From Grande Prairie, CanadaCurrentlyOfflineReputation:0(0%)
on my 1994 gt-four st205,the enginelight comes on. but whent the car warm it does not come on it reads code 54 through diognostics. tried topping up intercooler coolant and resetting ecu but stillcome...
1 replies Topic ID: 74759

hks boost controller help - 6G Celicas Forums

6th Generation Celica › Forced Induction
Started: EnthusiastJoined Mar 28, '10From Grande Prairie, CanadaCurrentlyOfflineReputation:0(0%)
Last reply: EnthusiastJoined Mar 30, '09From JamaicaCurrentlyOfflineReputation:0(0%)
i was wondering if anyone could explain how to reset the boost settings to stock settings??
I have an st205 with a hks evc, and it was running stock boost. Ater pushing a few buttons to try and incre...
5 replies Topic ID: 73332

removing stock struts st205 gt4 - 6G Celicas Forums

6th Generation Celica › Suspension/Handling/Braking
Started: EnthusiastJoined Mar 28, '10From Grande Prairie, CanadaCurrentlyOfflineReputation:0(0%)
Could anybody give the procedure on how to remove the gt4 superstrut from the car. i have it unbolted but i am at a stand still. even when it is unbolted it dosent even seem to wiggle loose at all. do...
0 replies Topic ID: 72998
Showing page 1 of 1 (7 total topics started)