📝 digs's Posts

digs

📍 southampton
Member
Posts
58
Vehicles
1

GT4 wing??? - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Exterior Styling
QUOTE (The_enD @ Jul 16, 2016 - 7:32 AM)
Personally it looks so much better with the blocks. The rear is kinda boring otherwise, all business in the front.
Black blocks, GT-FOUR letters in red ( I sel...
Topic ID: 96991 • Post ID: 9977509

3rd gen swap complete, running lean at idle and cruise - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
fair point
If did not have the GT4 option, would be very happy with mine
Topic ID: 95728 • Post ID: 9967151

3rd gen swap complete, running lean at idle and cruise - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
Absolutly love my rev3 3sgte in my fwd celica. however, coming from the uk, would have made far more sense to buy a gt4 in the first place, and could have with what I spent in the end. Mine def torqu...
Topic ID: 95728 • Post ID: 9967149

St205 Boost Issues - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
Have exactly the same issue. Think it's a weak actuator, a manual boost controller allows me to set boost at 14 psi all the way across, so guessing new actuator at some point!
Mine's actually worse, a...
Topic ID: 95212 • Post ID: 9963779

Help needed on st202 conversion - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
Can you not do a complete loom swap including ecu and sensors, or is there issues with that then? Deleting the aircon first.
This post has been edited by
digs
: Dec 20, 2014 - 7:40 AM
Topic ID: 94771 • Post ID: 9960437

Roof Rack??? - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Exterior Styling
There is an oem toyota one that was made to fit, not sure if they still do it though ? Pic of mine attached below;
Topic ID: 94109 • Post ID: 9958639

3SGTE engine swap GearBox question - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
yeah,very interesting, thanks for the nod, as above assume not straight fit or anything, but inners work ?
Topic ID: 93596 • Post ID: 9954342

3SGTE engine swap GearBox question - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
cheers dude
e56 box is def recommended, working well
Topic ID: 93596 • Post ID: 9954339

3SGTE engine swap GearBox question - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
Just an update, e56 now in and drive shafts are thicker, car "feels" more aggressive, whether this is due to confidence or the fact the power is going down better not sure
has got lsd so that could ex...
Topic ID: 93596 • Post ID: 9954337

3SGTE engine swap GearBox question - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
Thanks, maybe a combination of second parts rather than new that's causing it.... cheers
Topic ID: 93596 • Post ID: 9954336

3SGTE engine swap GearBox question - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
QUOTE (acidice333 @ Aug 29, 2014 - 7:57 PM)
Ive been using the st205 stock engine with a s53 for 2 years and its held up except I blew the engine. Upgraded to s54 now and engine is almost done being ...
Topic ID: 93596 • Post ID: 9954334

3SGTE engine swap GearBox question - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
Hi guys. Lot more experience with 3sgte swaps over here I believe
Mine went in, and initially was using a s54 box with SSI drive shafts. These got destroyed, the drive shaft box end had massive moveme...
Topic ID: 93596 • Post ID: 9954332

intercooler questions? - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
I used 2.25" pipes, and kept the fogs (post face lift though). Drivers side just goes under front and up behind the radiator, passenger side goes through where the air box was, under the fuse box and ...
Topic ID: 93273 • Post ID: 9943642

3SGTE swap - fuel pump relay/resistor - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
QUOTE (mkernz22 @ May 1, 2014 - 4:57 PM)
you need to get a walboro 255lph fuel pump for the 3sgte
Cheers
Have one of these fitted
http://www.tuningdevelopments.co.uk/produc...products_id=201
Had it on...
Topic ID: 92604 • Post ID: 9938910

3SGTE swap - fuel pump relay/resistor - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
QUOTE (Malek @ May 1, 2014 - 2:37 PM)
This should help..
http://www.6gc.net/forums/index.php?showtopic=65840
and if not..Here's another..
http://www.6gc.net/forums/index.php?showtopic=82196
Idk what t...
Topic ID: 92604 • Post ID: 9938908

3SGTE swap - fuel pump relay/resistor - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
should add, mechanic has a plan, but looking also at what other have done - actual fuel pump is aftermarket walbro equiv.
Topic ID: 92604 • Post ID: 9938906

3SGTE swap - fuel pump relay/resistor - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
I kinda have used the search, but was after an answer for an idot if anyone can help.....
3SFTE is out (after blowing cylinder 3.....) and 3sgte rev 3 going in! A mechanic, not my self, is doing the ...
Topic ID: 92604 • Post ID: 9938905

ST205 Front Wheel Bearings - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Suspension/Handling/Braking
QUOTE (DeanArm137 @ Apr 11, 2014 - 4:40 AM)
So glad I seen this thread, Ive just ordered a new front bearing unaware there was differences. I went to fit it and noticed the new one measured 74.3mm whi...
Topic ID: 92305 • Post ID: 9936232

FS: rx7 460cc injectors - now sold - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Buying/Selling
4 rx7 injectors, part number 195500-2010, 460cc. Bought these for my 3sfte project, but have now bought a 3sgte engine so not going to fix them. Look in good condition, but did not use them and bought...
Topic ID: 92047 • Post ID: 9933947

5SFE-5SFTE - 6G Celicas Forums

EnthusiastJoined Aug 2, '11From southamptonCurrentlyOfflineReputation:0(0%)
6th Generation Celica › Forced Induction
having done this (though with a 3sfe), would say brilliant way to get to know your engine and how to tune them, but if I was about to start again would do a 3sgte swap. DOn't regret it though
And prob...
Topic ID: 91485 • Post ID: 9929429
1 2 3 Next →
Showing page 1 of 3 (58 total posts)