📝 94odiecelica's Posts
FS: Parting out a 1994 GT - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
Hey I can come pickup, how much for the radiator?
Topic ID: 88592 • Post ID: 9801203
cats and o2 sensors - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
well the header flange and gasket meet right where the first cat goes. so in order to make the height of everything to fit, the first cat would need to be removed. i dont know if i misread your post o...
Topic ID: 85185 • Post ID: 9682321
cats and o2 sensors - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
hey guy, i have a header i wanted to install on my 94, 7a-fe, and it has 2 cats. with the new header i need to knock out the first cat. but from the engine it goes o2 sensor, cat, o2 sensor, cat, then...
Topic ID: 85185 • Post ID: 9682319
seals - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
so the side that goes into the trans, after the cv joint there is a seal that comes out and could be replaced? like the section that itself goes into the tranny and the cv boot, theres a seal that goe...
Topic ID: 84420 • Post ID: 9676712
seals - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
hey guys, i need to replace an axle, and was wondering if there was a seal on the cv joint where it meets the transmission. i dont have photo to use but right where the passenger side axle goes into t...
Topic ID: 84420 • Post ID: 9676710
belts - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
do you know what the last one is? power steering, alt. and water pump. those are the two i know. ande how would you change the third one?
Topic ID: 83711 • Post ID: 9671210
belts - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE (KAOS @ May 9, 2012 - 9:43 AM)
The power steering assembly is the tensioner for the power steering pump. You have to loosen it from underneath the car.
Easier to remove the wheel first, then you...
The power steering assembly is the tensioner for the power steering pump. You have to loosen it from underneath the car.
Easier to remove the wheel first, then you...
Topic ID: 83711 • Post ID: 9671208
belts - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
i was wondering if anyone had a link or could just tell me, is the tensioner under the alternator in a st the tensioner for all the belts? i have the 3s-fe and wanted to replace all the belts. i know ...
Topic ID: 83711 • Post ID: 9671206
car meet - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Meet/Event Discussion
my friend is putting on a car meet, and i was hoping to get some celicas there too. i dont think a lot of us will go but i would like to see some. pm me for directions, may 25, or heres a link with th...
Topic ID: 83256 • Post ID: 9666460
timing belt - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
i know this is a dumb question but im still kinda new to the site, where are the stickies?
Topic ID: 82799 • Post ID: 9662260
timing belt - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
is there anyway to do that without going to a garage? i know not to let them spin at all, but if they happen to, is a garage the only place to do that?
Topic ID: 82799 • Post ID: 9662257
timing belt - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
so when i change the timing belt, if the gears spin a little, my engine will be fine? wont be out of time?
Topic ID: 82799 • Post ID: 9662255
timing belt - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
i was just trying to find if the 7a-fe engine was non interfering with the pistons and valves for a timing belt change. i only did a little bit of research and just decided to try on here. if anyone c...
Topic ID: 82799 • Post ID: 9662253
WTB: clutch kits - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
QUOTE (BoostedRicer @ Feb 21, 2012 - 9:27 AM)
Not really, but I can't tell its condition like until i pull it. I didn't put it in, so i don't know. I'm sure its not wore out. My car's parts are in goo...
Not really, but I can't tell its condition like until i pull it. I didn't put it in, so i don't know. I'm sure its not wore out. My car's parts are in goo...
Topic ID: 82459 • Post ID: 9658703
WTB: clutch kits - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
QUOTE (BoostedRicer @ Feb 21, 2012 - 3:21 AM)
well they go for new online for 300. i'd like to get only 150 and i'll do the labor to pull it and ship it out to you for 150. let me know
ok, can i get a...
well they go for new online for 300. i'd like to get only 150 and i'll do the labor to pull it and ship it out to you for 150. let me know
ok, can i get a...
Topic ID: 82459 • Post ID: 9658701
WTB: clutch kits - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
how much would you want for it before you do any work
Topic ID: 82459 • Post ID: 9658699
WTB: clutch kits - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
QUOTE (BoostedRicer @ Feb 20, 2012 - 12:31 PM)
QUOTE (94odiecelica @ Feb 20, 2012 - 12:00 AM)
just trying to look for some clutch kits better than OEM. got ripped off by buying parts on ebay so im try...
QUOTE (94odiecelica @ Feb 20, 2012 - 12:00 AM)
just trying to look for some clutch kits better than OEM. got ripped off by buying parts on ebay so im try...
Topic ID: 82459 • Post ID: 9658697
WTB: clutch kits - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
just trying to look for some clutch kits better than OEM. got ripped off by buying parts on ebay so im trying to stay away from there. but anyone got anything worth lookin at?
Topic ID: 82459 • Post ID: 9658694
FS: List of most recent parts available with pics! New Items at bo - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
how much would you want for the strut bar to 16354
Topic ID: 82449 • Post ID: 9658511
nitro - 6G Celicas Forums
EnthusiastJoined Jan 24, '12From titusville paCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
QUOTE (mkernz22 @ Feb 16, 2012 - 8:57 PM)
why would you even bother doing that with a 7A?
just an idea
why would you even bother doing that with a 7A?
just an idea
Topic ID: 82428 • Post ID: 9658263
Showing page 1 of 3 (51 total posts)