📝 rdyzz's Posts
rdyzz
📍 minnesota
Member
Posts
78
Vehicles
0
how to swap a 2grfe V6 into a st204 - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE (BonzaiCelica @ Nov 26, 2015 - 6:46 PM)
Ya no way the V6 is going to be louder than the 4 banger. Only thing I dislike about the V6 it doesn't sing that high like a 350z
Mine free reving. It sin...
Ya no way the V6 is going to be louder than the 4 banger. Only thing I dislike about the V6 it doesn't sing that high like a 350z
Mine free reving. It sin...
Topic ID: 93458 • Post ID: 9945453
how to swap a 2grfe V6 into a st204 - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE (Bitter @ Nov 26, 2015 - 9:16 AM)
Dang that's loud.
Funny you say that, I found the v6 2gr to be even quieter than my beams 3sge, even now on 2 resonators it is at just about the right sound lev...
Dang that's loud.
Funny you say that, I found the v6 2gr to be even quieter than my beams 3sge, even now on 2 resonators it is at just about the right sound lev...
Topic ID: 93458 • Post ID: 9945437
how to swap a 2grfe V6 into a st204 - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE (Bitter @ Nov 21, 2015 - 9:58 AM)
That's all torque from the word go. A lot of the custom wiring could be tamed by running a stand alone ECM with a much simpler throttle and ignition setup. I kn...
That's all torque from the word go. A lot of the custom wiring could be tamed by running a stand alone ECM with a much simpler throttle and ignition setup. I kn...
Topic ID: 93458 • Post ID: 9945423
how to swap a 2grfe V6 into a st204 - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Nice hopefully you get it running soon.
I just did a test and tune with mine yesterday.
https://www.youtube.com/watch?v=qALQeveWdkc...eature=youtu.be
This post has been edited by
rdyzz
: Aug 14, 2015 ...
I just did a test and tune with mine yesterday.
https://www.youtube.com/watch?v=qALQeveWdkc...eature=youtu.be
This post has been edited by
rdyzz
: Aug 14, 2015 ...
Topic ID: 93458 • Post ID: 9945387
how to swap a 2grfe V6 into a st204 - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Hows your shift cables clear your swap? on my Corolla I had to build the rear header around that problem.
Topic ID: 93458 • Post ID: 9945383
how to swap a 2grfe V6 into a st204 - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
I have nothing against the Honda J32 or other v6 swaps, but for some reason the 2grfe to me is just a better looking engine. I don't know why that is, must be a twin cam thing.
Topic ID: 93458 • Post ID: 9945375
Smaay ! V6 vs. Beams - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
lol this thread... if only there were a way to slap two 3s heads on a v6 bottom end it would be comparable, but until then no amount of technology is going to give a 2L the same powerband as 3-3.3L no...
Topic ID: 90719 • Post ID: 9922107
Smaay ! V6 vs. Beams - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
i'd love to have a 1mz or 2gr in a celica that being said its not comparable lol. your comparing a v6 with 1000cc more displacement to a 4 cylinder engine, not amount of valve lift, valve timing techn...
Topic ID: 90719 • Post ID: 9922034
redtop 3sge woe's - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
the coolant passage must be rerouted in the throttle body. i have not done much analyzing of it since i installed the iac with the throttle body on the car. here's a picture of what it looks like in t...
Topic ID: 90718 • Post ID: 9921953
redtop 3sge woe's - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
the one with the two port is the civic one, the one with the single port is the 3sge's. it only has one port cause it has a thermostatic water inlet for the other one. also the only reason there is fo...
Topic ID: 90718 • Post ID: 9921951
redtop 3sge woe's - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
it was $156 at the local oreilys, but since its for a civic its probably readily available cheaper through other sources.
Topic ID: 90718 • Post ID: 9921947
redtop 3sge woe's - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
found out the 2001 honda civic 1.7L iac is basically identical to the beams redtop. so i purchased one and am using it with excellent results.
Topic ID: 90718 • Post ID: 9921944
redtop 3sge woe's - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
so with the ecu reset, the car started out with a 3k rpm idle then went to 2k and stayed there for 10min. i drove it and it dropped down to 1,500 rpms but was surging when i would stop for the stop l...
Topic ID: 90718 • Post ID: 9921943
redtop 3sge woe's - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
thanks guys for adding the link i thought the site was down.
so after cleaning it yesterday, the morning seemed like it drove strong. then at lunch time i went for a drive and it did the same thing ag...
so after cleaning it yesterday, the morning seemed like it drove strong. then at lunch time i went for a drive and it did the same thing ag...
Topic ID: 90718 • Post ID: 9921942
redtop 3sge woe's - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
beams owners sites been down for me as well, the car drove well for two days and sunday it started acting up again. shifting gear at times cause a stumble when i add throttle. this is very annoying i ...
Topic ID: 90718 • Post ID: 9921938
redtop 3sge woe's - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
thanks richee3, well see if this does anything. i took off the iac and cleaned it pretty well. the pn on the motor is 22270-7437 and the last number is shaved, the beams ends with a 0. looks like whoe...
Topic ID: 90718 • Post ID: 9921936
redtop 3sge woe's - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
so i sprayed some carb cleaner into the iac port and it seemed to have made a difference. without the air filter and the tb exposed i can clearly hear the drill like noise.
i took it off to clean it f...
i took it off to clean it f...
Topic ID: 90718 • Post ID: 9921934
redtop 3sge woe's - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
compression tested 180, 175, 175, 170. it was just me cranking on my odyssey 680 and no one to look at the gauge.
the fuel stuff was changed in due to the dyno tuner being a friend and ase certified t...
the fuel stuff was changed in due to the dyno tuner being a friend and ase certified t...
Topic ID: 90718 • Post ID: 9921931
redtop 3sge woe's - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
the long
so my engine has been running like its on two maps or somthing. it started doing this after the last track event in july, i've been trying different things on it since then. its a redtop 3sge...
so my engine has been running like its on two maps or somthing. it started doing this after the last track event in july, i've been trying different things on it since then. its a redtop 3sge...
Topic ID: 90718 • Post ID: 9921927
Less camber via control arms - 6G Celicas Forums
EnthusiastJoined Dec 27, '11From minnesotaCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Suspension/Handling/Braking
using two sets of adjustable control arm will allow you to adjust camber, but by doing so your affecting the rear track. btw tilting the strut more wont have any negative affects to the rear, its a st...
Topic ID: 90549 • Post ID: 9919943
Showing page 3 of 4 (78 total posts)