📝 scothaniel's Posts
GT4 Strut bar strut covers. - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Interior/Audio/Electrical/Wiring
#### Note to US Members - Only 2 pairs left in stock! #####
I just ordered a pair of the strut covers from my local parts supplier today and there were only 4 left in stock - and the part number is...
I just ordered a pair of the strut covers from my local parts supplier today and there were only 4 left in stock - and the part number is...
Topic ID: 32718 • Post ID: 7090890
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
Do you have limited slip? Perhaps your one of the unlucky few who needs the exact matching stub:
http://www.mr2board.com/forums/turbo-3s-gt...-lsd-stubs.html
http://www.mr2board.com/forums/turbo-3s-gt...-lsd-stubs.html
Topic ID: 32626 • Post ID: 7089638
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
I did have it up on jacks, and it seamed to be fine. No binding, and the axle had enough space to compress/extend. It's just at this one point where it locked up. I've already replaced it and I'll ju...
Topic ID: 32626 • Post ID: 7089636
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
Okay, I guess I'm not special.
Last weekend I snapped the passenger side axle. I was driving around a corner and punched it, and soon as the boost hit I heard a loud bang and the car just glided to a ...
Last weekend I snapped the passenger side axle. I was driving around a corner and punched it, and soon as the boost hit I heard a loud bang and the car just glided to a ...
Topic ID: 32626 • Post ID: 7089634
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
With the full spacer in, can you turn the steering wheel side to side without it binding or resisting?
As long as axles can properly depress for turns, and the axle isn't forcing the wheel out of alig...
As long as axles can properly depress for turns, and the axle isn't forcing the wheel out of alig...
Topic ID: 32626 • Post ID: 7089627
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
Only passenger side has the spacer.
Topic ID: 32626 • Post ID: 7089623
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
The cross member is the same on all 6th gens.
The front engine mount is the same on all 6th gens.
I've yet to find a difference between the GT and 205 passenger side mount. Maybe the rubber compand in...
The front engine mount is the same on all 6th gens.
I've yet to find a difference between the GT and 205 passenger side mount. Maybe the rubber compand in...
Topic ID: 32626 • Post ID: 7089620
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
I'm using the full outer carrier.
Topic ID: 32626 • Post ID: 7089563
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
passenger side only.
Everyone seems to go more complicated then what I did. Buy a blown outer axle on the all-trac forum for the price of a core charge ($30 or so) and separate the outer carrier by r...
Everyone seems to go more complicated then what I did. Buy a blown outer axle on the all-trac forum for the price of a core charge ($30 or so) and separate the outer carrier by r...
Topic ID: 32626 • Post ID: 7089558
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
I am, full spacer - no problems.
Topic ID: 32626 • Post ID: 7089537
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
Thats interesting - I have the lsd drivers side inner, non-lsd passenger side inner in the E153 w/ TRD diff installed. I know the drivers side MUST be lsd (tried non-lsd and it leaked) but I didn't th...
Topic ID: 32626 • Post ID: 7089526
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
I think my inner axels went in another inch after getting past the snap ring. I might be able to get under my car tonight and get some pics. 800 miles so far, and no problems with my setup.
Here is w...
Here is w...
Topic ID: 32626 • Post ID: 7089524
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
I'm confused - can you run through that again?
The way I read it, it sounds like your converting the AWD E150F transmission to 2WD by removing the center diff and installing the MR2 diff housing plate...
The way I read it, it sounds like your converting the AWD E150F transmission to 2WD by removing the center diff and installing the MR2 diff housing plate...
Topic ID: 32626 • Post ID: 7089499
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
I also checked the urbandictionary - but I didnt think "Love Sick Puppy" applied here!
Topic ID: 32626 • Post ID: 7089493
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
QUOTE
3 letters
L. S. P
Got any more letters - can I buy a vowel?
Not quite sure what your referring to. A quick Google search found Louisiana State Police, London Sailing Project, and my favorite - L...
3 letters
L. S. P
Got any more letters - can I buy a vowel?
Not quite sure what your referring to. A quick Google search found Louisiana State Police, London Sailing Project, and my favorite - L...
Topic ID: 32626 • Post ID: 7089489
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
Just bought a few of these 10mm x 1.5 x 90mm CL 12.9 socket head machine screws today from Fastenal for my axel:
http://www.fastenal.com/web/products/detail.ex?sku=1139628
Since they didn't have any o...
http://www.fastenal.com/web/products/detail.ex?sku=1139628
Since they didn't have any o...
Topic ID: 32626 • Post ID: 7089483
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
For fasteners:
http://www.fastenal.com/
http://www.fastenal.com/
Topic ID: 32626 • Post ID: 7089482
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
QUOTE
I have spoken to several wreckers in my area who swear that both shafts are same but they're clearly not
According to Toyota they are the same. Same part number in the EPC, and the last set I or...
I have spoken to several wreckers in my area who swear that both shafts are same but they're clearly not
According to Toyota they are the same. Same part number in the EPC, and the last set I or...
Topic ID: 32626 • Post ID: 7089474
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
Its 2 All-Trac CV housings for sure (outer-race for the proper name).
I bought a trashed 185 outer shaft from a buddy, separated the outer-race and added it between the MR2 inner and current 185 outer...
I bought a trashed 185 outer shaft from a buddy, separated the outer-race and added it between the MR2 inner and current 185 outer...
Topic ID: 32626 • Post ID: 7089467
The MR2T tranny "short axel" solution - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
I have a spare set I can take some pics of.
There is one thing that troubles me about the picture. If they did indeed bolt a second CV housing between the inner shaft and outer axle, how would this ef...
There is one thing that troubles me about the picture. If they did indeed bolt a second CV housing between the inner shaft and outer axle, how would this ef...
Topic ID: 32626 • Post ID: 7089449
Showing page 20 of 24 (475 total posts)