📝 scothaniel's Posts
FS: ST205 Front Brakes / Suspension - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
$900, and I'll throw in some suspension parts for free!
Sorry, not going to part this one out.
Sorry, not going to part this one out.
Topic ID: 35551 • Post ID: 7305386
FS: ST205 Front Brakes / Suspension - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
For sale - ST205 Front brakes and superstrut suspension setup
*** See below for new pics ***
I've been sitting on these for a while now and decided to stick with the stock GT parts. So here it is - th...
*** See below for new pics ***
I've been sitting on these for a while now and decided to stick with the stock GT parts. So here it is - th...
Topic ID: 35551 • Post ID: 7305384
What happened? - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› General Discussion
That happened to me on a highway on-ramp once. Slightly wet road and rear tires were worn.
Topic ID: 35540 • Post ID: 7305144
Ignition Info - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
custom pipe = exhaust then?
Got it.
Ignition control may be able to make a little more power, but dont look for anything too drastic.
Got it.
Ignition control may be able to make a little more power, but dont look for anything too drastic.
Topic ID: 35524 • Post ID: 7304974
Ignition Info - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Spend the money on an exhaust first.
This post has been edited by
scothaniel
: Mar 29, 2006 - 12:39 AM
This post has been edited by
scothaniel
: Mar 29, 2006 - 12:39 AM
Topic ID: 35524 • Post ID: 7304972
Opening a can of worms? - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Keep in mind that the only difference with the JDM motor is the lack of EGR and the ECU programming. That is it!!!! You can trade the guys on the alltrac net for thier USDM ecu and I'm sure they th...
Topic ID: 35509 • Post ID: 7304806
Opening a can of worms? - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE
any motor you buy, 3sGE or 3sGTE will be something out of a junk yard or a wrecked car
Words of wisdom!
I say pick up a used 3SGTE motor off mr2oc.com or ebay and spend the money to have rebuilt...
any motor you buy, 3sGE or 3sGTE will be something out of a junk yard or a wrecked car
Words of wisdom!
I say pick up a used 3SGTE motor off mr2oc.com or ebay and spend the money to have rebuilt...
Topic ID: 35509 • Post ID: 7304802
Stuck Idling at 2,000 - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
No really! It works great. I use it all the time looking for exhaust leaking in IC piping. No mess and not harmful to rubber seals.
Topic ID: 35493 • Post ID: 7304689
Stuck Idling at 2,000 - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Or use propane / map gas (soldering torch). Same situation as the carb cleaner.
Topic ID: 35493 • Post ID: 7304687
3sgte Running Reallly rich! - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
The 1v a/f gauges are not all that bad. Sure your not getting the full spectrum and they are not nearly as accurate for tuning a piggyback / standalone system. But if your running the factory ECU, the...
Topic ID: 35455 • Post ID: 7304152
180 hp jdm engine? - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Installed myself. You'll notice a lot more top end pull compared to the 5S. Low end torque is about the same. I've installed low-comp pistons to run a turbo, but even with the turbo disconnected I'm r...
Topic ID: 35449 • Post ID: 7304073
180 hp jdm engine? - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
FYI - I bought a 3rd gen 3SGE with harness, ecu, sensors, trans, axles, brakes, and suspension for $1000 from Jarco.
Topic ID: 35449 • Post ID: 7304068
turbo expert needed - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
So, your asking if its possible to fit the CT20B compressor and wheels/shaft into a CT26 Exhaust housing?
Thinking while typing.....
The CT26 on the 7MGTE will fit a CT20B turbine without modification...
Thinking while typing.....
The CT26 on the 7MGTE will fit a CT20B turbine without modification...
Topic ID: 35444 • Post ID: 7304034
3sfe to 3sge ... kinda - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
You may also want to check out the Rav4 groups, as they have the 3SFE's and like doing swaps!
This post has been edited by
scothaniel
: Mar 27, 2006 - 2:58 PM
This post has been edited by
scothaniel
: Mar 27, 2006 - 2:58 PM
Topic ID: 35436 • Post ID: 7303926
Hybrid Axle installation - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
See SA-67:
http://www.mr2-tech.com/bgb/mechanical/vol...and_axle/10.htm
http://www.mr2-tech.com/bgb/mechanical/vol...and_axle/10.htm
Topic ID: 35431 • Post ID: 7303845
5 speed tranny question - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
This is exactly what dealerships are for! Go find a Celica ST or older Corolla 5spd and check it out. If you dont know how to drive a stick, dont worry! They'll replace it....
Topic ID: 35397 • Post ID: 7303394
what turbos fit on the 3sgte - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
With the right adapter - any turbo will fit.
Topic ID: 35380 • Post ID: 7303114
ST205 3SGTE with MR2T E153 tranny - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
QUOTE
You need the rear axles from what ever year the tranny is from
Also, the drivers side inner axles are different for the LSD trans. I had a non-lsd axle in a lsd equiped trans and it leaked badly...
You need the rear axles from what ever year the tranny is from
Also, the drivers side inner axles are different for the LSD trans. I had a non-lsd axle in a lsd equiped trans and it leaked badly...
Topic ID: 35362 • Post ID: 7303009
need a new trans - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
QUOTE
No since it has the 1zz-ge engine in it not the 7a-fe.
Actually, the newer Celica's are using a newer version of the same C series trans as the 7A's and 4A used. I'm pretty sure they'll bolt rig...
No since it has the 1zz-ge engine in it not the 7a-fe.
Actually, the newer Celica's are using a newer version of the same C series trans as the 7A's and 4A used. I'm pretty sure they'll bolt rig...
Topic ID: 35342 • Post ID: 7302829
Exaust manifold - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
Love Fab also makes some killer systems:
http://www.lovefab.com/06/
This post has been edited by
scothaniel
: Mar 24, 2006 - 2:11 PM
http://www.lovefab.com/06/
This post has been edited by
scothaniel
: Mar 24, 2006 - 2:11 PM
Topic ID: 35315 • Post ID: 7279812
Showing page 15 of 24 (475 total posts)