📝 scothaniel's Posts
ToYSport 3SGTE SWAP - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› General Discussion
The stock 440cc injectors are more then adiquite for the CT26 turbo. No need to upgrade there.
If you can get away with it, ditch the EGR and have a block-off plate made (it would cost around $30). Be...
If you can get away with it, ditch the EGR and have a block-off plate made (it would cost around $30). Be...
Topic ID: 3696 • Post ID: 7338781
YES 3sgte with a 5s stock tranny. - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
QUOTE
in that other thread in the n/a forum, someone has e56 with SS setup, so it might not be possible, or atleast without a suspension swap
Superstruts and McPherson setups are interchangable. I've ...
in that other thread in the n/a forum, someone has e56 with SS setup, so it might not be possible, or atleast without a suspension swap
Superstruts and McPherson setups are interchangable. I've ...
Topic ID: 36968 • Post ID: 7338729
YES 3sgte with a 5s stock tranny. - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
QUOTE
will the e56 bolt on to our setups easier than the e153?
Since its an E-series trans, it'll have most of the same issues as the E153. I've seen a pic of one once, and it looked just like the E15...
will the e56 bolt on to our setups easier than the e153?
Since its an E-series trans, it'll have most of the same issues as the E153. I've seen a pic of one once, and it looked just like the E15...
Topic ID: 36968 • Post ID: 7338728
YES 3sgte with a 5s stock tranny. - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
Also, if anyone wants the ISO's for the JDM 97 EPC, I can put them up on my works sftp site later. You'll need the actual EPC program to run them, these are only the data disks.
Topic ID: 36968 • Post ID: 7338721
YES 3sgte with a 5s stock tranny. - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
The Tranny I sold Dustin (and is now owned by defgeph). Came from a 1996 Toyota Curren. RHD, 3rd gen 3SGE and non-lsd. I checked the part numbers from my copy of the 97 EPC, and the hubs, brakes, su...
Topic ID: 36968 • Post ID: 7338720
were can i get a st205 wiring harness - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
Are you installing a 205 engine into a 6th gen? If so, is it a ST or GT?
I have the pin-outs for the 205 (which should also be listed on the ECU motherboard) and converted a ST185 harness for the 205 ...
I have the pin-outs for the 205 (which should also be listed on the ECU motherboard) and converted a ST185 harness for the 205 ...
Topic ID: 3587 • Post ID: 7309363
twin turbo???? - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
QUOTE
ok #1) its not NOS thats a brand....its called nitrous...
And yet, when I say NOS everyone knows what I'm talking about.
QUOTE
its complicated, it takes time and effort and of course money...its...
ok #1) its not NOS thats a brand....its called nitrous...
And yet, when I say NOS everyone knows what I'm talking about.
QUOTE
its complicated, it takes time and effort and of course money...its...
Topic ID: 35859 • Post ID: 7309140
twin turbo???? - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
Twin charger setups were attempted by a number of 1st gen MR2 owners. Most complained of the extra complexity caused more trouble then benifit. Of course that was almost 20 years ago.
If you want a hu...
If you want a hu...
Topic ID: 35859 • Post ID: 7309136
twin turbo???? - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
completely pointless
Topic ID: 35859 • Post ID: 7309118
Got My 'RC' Motor Today - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
RC ECU wiring is similar to the 92-93 standard ST185 wiring. The 90-91 harness is a bit different. You'll also have extra wires for the IC setup as compared to the standard 185 harness
The Mines ECU s...
The Mines ECU s...
Topic ID: 35763 • Post ID: 7308083
Got My 'RC' Motor Today - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
You can definately tell if the AFM is an RC - its like 50% bigger in size. Wiring wise, it has one extra ground. The sensitivity of the meter is different from the standard 185 - if you put the RC A...
Topic ID: 35763 • Post ID: 7308079
Got My 'RC' Motor Today - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
Open up the ECU and look at the pinout stamped on the board. The existance of an INT pin should tell you if the ECU is an RC.
Did you get the WA intercooler ECU with the swap?
This post has been edite...
Did you get the WA intercooler ECU with the swap?
This post has been edite...
Topic ID: 35763 • Post ID: 7308076
SOB: I quit - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Engine/Transmission/Maintenance
I'm with Fastbird - sounds like a fuel line issue. I had a clogged filter in the tank (bad gas compliments of Shell) and it did the same thing.
Topic ID: 35724 • Post ID: 7307617
what to look for in a fmic - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Forced Induction
If your running a stock or mildly upgraded ct2x turbo, just about any FMIC will do the job. Stock EVO or Neon SRT, DSM FMIC (Dejon Tool, slowboy, etc), Small Greddy (31V) or small Spearco like play15...
Topic ID: 35711 • Post ID: 7307448
C-ONE C/F hood - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Exterior Styling
QUOTE
I went to ToYSport on WEDNESDAY, June 4. That guy there said he has never heard of a alloy hood? "There is no such thing. Its all steel" those were his words.
That's bs. I've got two of them in ...
I went to ToYSport on WEDNESDAY, June 4. That guy there said he has never heard of a alloy hood? "There is no such thing. Its all steel" those were his words.
That's bs. I've got two of them in ...
Topic ID: 3570 • Post ID: 7307435
C-ONE C/F hood - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Exterior Styling
I just bought my ST205 hood and bumper for around $850.
Geoff Mohler (aka Celica Guru) is going to be offering them as a kit / group buy pretty soon. Check with him before you pay too much: gemohler@w...
Geoff Mohler (aka Celica Guru) is going to be offering them as a kit / group buy pretty soon. Check with him before you pay too much: gemohler@w...
Topic ID: 3570 • Post ID: 7307432
FS: ST205 Front Brakes / Suspension - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
Bump...
Topic ID: 35551 • Post ID: 7305395
FS: ST205 Front Brakes / Suspension - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
4 Easy installments of
QUOTE
200 shipped
and its yours!
QUOTE
200 shipped
and its yours!
Topic ID: 35551 • Post ID: 7305393
FS: ST205 Front Brakes / Suspension - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
I'd recommend 17" minimum, though the stock 205 rims are 16".
Topic ID: 35551 • Post ID: 7305391
FS: ST205 Front Brakes / Suspension - 6G Celicas Forums
EnthusiastJoined May 1, '03From MichiganCurrentlyOfflineReputation:0(0%)
6th Generation Celica
› Buying/Selling
Bump with new pics -
Everything needed for the swap:
Tie rod ends, superstruts, hubs...
Brake close up:
And a few comparisions with the stock ST front brakes for those who dont know how big of a brake...
Everything needed for the swap:
Tie rod ends, superstruts, hubs...
Brake close up:
And a few comparisions with the stock ST front brakes for those who dont know how big of a brake...
Topic ID: 35551 • Post ID: 7305388
Showing page 14 of 24 (475 total posts)