Engine/Transmission/Maintenance
14,249
Total Topics
25
Showing
83
Page 83 of 570
Topics in Engine/Transmission/Maintenance •
newest topics first
Changed the bulb and fuses checked. Any suggestions on what may be wrong?...
20w50 is what I use. Being you're in the south as well, you'll be fine....
Bad throw out bearing (release bearing) had same problem when I installed my new clutch got some cheap Chinese TOB lasted 3weeks. Started to make nois...
Agree, there should be nuts on both spots and studs. BTW, Fram is the worse oil filter known to man....
Mine is 60psi on a cold start an drops to around 17-19 at idle after warmup an is normally around 60psi at highway speeds...
actually used a gt drivers mount..
had to flip the lower bracket and cut off a section of the gt isolator
the ST205 drivers mount should be bolt on if...
look under the hood on the driver side of the engine, you should be able to find the shifter cable links, follow them back to the firewall see if some...
i found that in 3 min via google...
Is this the same issue as in this
thread?...
Hey guys,
Currently engine drips oil under hard driving......found the problem, the oil feed line to the turbo (one from middle of the block)
i know i...
can anyone point me in the right direction?...
Air intake, not gonna affect the afr enought to cause that
O2, good possibility. can go bad w/o throwing a code.... i had one go bad and lean my 7a ou...
I can't comment on the OBD2 version, but I know with my headers (which I had coated and wrapped) you notice more pull in the higher RPM range. Which i...
^^Of course the above. Things on cars like to die suddenly at times....
alright but there has to be some sort of silicone for the inner seal from the bottom of the header into the exhaust. That ring like seal correct?...
hhmmm sounds like you did everything right. my first guess would be the PCV, is it possible you have the hose routing wrong and still pressurizing the...
Anyone got a suggestion for how to clean some of the gunk out without pulling the entire engine apart
i dont care if i need to pull of stuff like the ...
here is a link for you
http://www.6gc.net/forums/index.php?showtopic=72502&hl
the stickys are the top sections of every forum
This post has been edite...
bump for sticky or including this in a sticky thread...
either the linkage came apart or a cable broke. just going to have to take things apart and see for yourself...
Hi guys,
I have a 97 ZR model (the Australian GT). I was under the impression that 96+ models were all OBD II, but maybe thats only in America?
I was ...
Hey guys,
I'm looking for a Distributor that fits in the FE head that's better than our stock ones. I need one with at least a 24-1 wheel. I'm using a...
double post.
This post has been edited by
lagos
: May 14, 2012 - 12:00 AM...