Engine/Transmission/Maintenance

14,249 Total Topics
25 Showing
180 Page 180 of 570
Topics in Engine/Transmission/Maintenance • newest topics first
7 posts • Started by 6G96GT
a CAI style intake will actually get you less intake sounds and the same acceleration....
2 posts • Started by jeffrosie
Need some help please. I need the part numbers for the bearing bracket that holds the longer driveshaft onto the E153 box. Pressure2 gave me the part#...
11 posts • Started by azn87
^^^wouldn't hurt driving performance, but if you forget to turn it off while you work or leave the car, it will drain the battery....
5 posts • Started by Igorkatayev
Its the same as the other TPS found on the toyotas....
2 posts • Started by 99Celica
bump, could use some input...
9 posts • Started by blu94gt
Bump.. anyone else?...
1 posts • Started by ledge
I was planning on draining my atf this weekend and I was wondering how many quarts of atf do i need to refill the transmission....
2 posts • Started by revski
hey will a 2000-2005 gt celica Engine fit and work in my 96 celica st. my 96 celica engine is burning oil bad and i what some more pick up out of my...
3 posts • Started by nics
go back to the forums... look at the very top... sticky's... 6th or so post down...
14 posts • Started by 92-gt
hey well i just recently changed my clutch on my car a month ago. I dont think its that hard. Well i didnt know how to do it. So i had my friend help ...
2 posts • Started by nookiemonsta
After some pics of your SRI or CAI Ive made up mine and it doesnt seem to fit quite right so id like to see what you all have done thanks...
3 posts • Started by domyz
ACT isn't recommended they use soft disc who don't hold a lot of HP and they compensate with very hard pressure plate which give a bad pedal feeling/s...
2 posts • Started by NAfire185
Anyone got any tips on adjusting it? I guess you just loosen it off abit then turn and tighten it up?...
12 posts • Started by Bitter
Hi, I need some help with my radiator, the water is pretty dirty. I think I might go to my parents tomorrow and try to flush the system but have anyon...
4 posts • Started by enderswift
Hey, this and my hydro clutch is the only thing stopping me from pulling out the motor. How do i get these two lines out and how should i disconnect t...
5 posts • Started by 808celica
I'm using NGK wires and NGK Lasers good combo no complaints here....
7 posts • Started by hurley97
Got tired of waiting on forgotten goods (how someone forgets to bring a camera 3 times in a row .. beyond this dude), and I couldn't contain myself an...
6 posts • Started by BonzaiCelica
A lot of people have this header. Myself included. They replace the exhaust manifold and primary cat. They bolt right up to the flex pipe section. ...
4 posts • Started by 808celica
correction, i actually looked at the O2 sensor that I took off my car and it says 89465-20420 which is the california spec O2 sensor. below it it says...
2 posts • Started by ksporry
If I were to replace my engine, would I have to drop it from the bottom, or can I lift it out from the top? this matters as I dont have a lift or anyt...
14 posts • Started by BonzaiCelica
could go hybid and do a 7age ive contenplated getting a spare engine and building one, you would have the same or a lil more hp than a 5s but a lighte...
2 posts • Started by CelicaGTWolf
90099-00200 hit your local toyota dealer with that part #....
5 posts • Started by Bitter
a lot of garages around here don't know there arse from there elbow so wanted to try and get a second opinion. has anybody every fitting an oil pump i...
22 posts • Started by 6gsillyca
any chance you wanna send me some more info about your dual exhaust setup?? i was wanting to do the same. very interested in how yours was done, pics ...
4 posts • Started by Dennisj1
Hey Guys, I have 1994 ST 1.8L Celica with an automatic 7AFE engine and i have a few questions about the engine. 1st. I just realised that i have to ch...