Engine/Transmission/Maintenance

14,249 Total Topics
25 Showing
132 Page 132 of 570
Topics in Engine/Transmission/Maintenance • newest topics first
5 posts • Started by njccmd2002
For labor alone?...
10 posts • Started by AMCMoe
Awesome. Yeah i'm pretty sure it is the master cylinder alone also. Thanks for the walk through These were the answers i need. It would help if 6gc ha...
5 posts • Started by cheela
I found a complete 1994 GT with 127km ( written off due to rear end accident) and I have a 1994 ST. I know I need the transmission, engine and trans m...
12 posts • Started by Import_Freak
Haha very smart! Did you tighten them down with a torque wrench or just a ratchet??...
5 posts • Started by 96stgreendemon
Finally found the gasket today, well similar had to modify it a little but it works now, found it at an exhaust shop...
4 posts • Started by stephen_lee
i just need to find a good realiable place to buy one, so that i can drop it in, and have my darling celica running again....
11 posts • Started by barterj
I assumed a needed the cali spec cat. because of the oxygen sensor right after the first cat. Won't the car run a bad fuel+air ratio if the sensor is ...
5 posts • Started by 4-eyed-freek
does anyone have one of these things, im thinkin about buying one soon. any power gains? and can anyone discribe the install of one of these, is it ha...
3 posts • Started by SanFlip
http://www.6gc.net/howto/swap_auto_transmission_to_manual...
13 posts • Started by Bitter
ah rebuilding a 5sfe hm nice build btw. but I would of went with a 3rd gen 3sge they are pretty cheap off ebay for $800 plus shipping!...
7 posts • Started by 95celicastLSR
check behind the head, just use your eyes and LOOK!! get a flashlight, get a friend, get a mirror and LOOK. if you don't know where its coming from or...
13 posts • Started by 808celica
But the one that is missing is the one with the two prongs, will the rc clip still work?...
10 posts • Started by NOVAKx17
16 chain links on the drivers side hook, 4-5 on the passanger side. use a jack to lower the drivers side down, and it comes right out. no need for the...
6 posts • Started by 4-eyed-freek
How long would it take to air dry indoors? I'm living in college dorms, I can't really leave a performance intake filter laying around outside to dry....
6 posts • Started by Falken_GTS
An Injen Cyborg SRI will fit. It's what I have in my 95 ST.... it barely fits But I bought it from trdproven, he had it on his car and he has a 3SGE. ...
21 posts • Started by fgvillegas
a whole lot of stuff, best to check the repair manual in the NA sticky thread, to see what you need to do. any chance of going back to the person who ...
6 posts • Started by jbspeed
My friend's car, a '94 ST, broke down today. It will start, and immediately run really rough, and it's leaking oil. A lot. I only ran it for a few ...
6 posts • Started by CELICA735
Actually is bolt up i got GT rotors and calipers for the front of my ST works like a charm!...
7 posts • Started by Hanyo
Forget the AWD get a 2JZ and RWD it !!!!!!!!!!!!!...
9 posts • Started by BonzaiCelica
A few things to consider when choosing stainless : 1. It's heavier than aluminum piping 2. It's hardier to weld 3. It's more expensive Not sure if the...
8 posts • Started by HectortheRican
2 1/4 is as big as you should go on a N/A car. You can go 2.5 but it isnt much a difference than 2 1/4. And you can get the gasket at any parts sto...
42 posts • Started by 95CelicaST
after poking around and trying different things, found a little oil in the distributor so cleaned it out and replaced the cap/rotor after they looked ...
26 posts • Started by Johnnyny
Alright! thank you manny! I just got the specs and the a2m checklist from the stickies, going to hopefully get everything during the winter to spring ...
14 posts • Started by Arsaces
5w30 for colder weather and for hotter weather 10w30 I change mines when the temps change for best protection....
2 posts • Started by 95CelicaST
Spark plug tube gaskets....