Engine/Transmission/Maintenance
14,249
Total Topics
25
Showing
117
Page 117 of 570
Topics in Engine/Transmission/Maintenance •
newest topics first
check that you have good clean tight connection to the battery, try tapping the starter with a long rod or a hammer while someone tries to crank it....
An inch back really isn't going to be a noticeable increase, much better focusing on other mods, putting a lighter engine in it such as a 4AGE with an...
QUOTE (Lil-Joe101 @ Mar 19, 2011 - 7:34 PM)
Yeah dude, teflon tape. Wrap the threads before u but it back in. Havent had any trouble from mine at all....
Im pretty sure that has nothing to do with auto vs manual. I'm pretty sure its fed vs cali spec. The cali spec has an external coil, its located on ...
Downpipe isn't long enough, will need an extension welded on.
Gaskets are cheap and blow out easy.
Will lose some bottom end, but gain the other end o...
Hello ppl, the other day i was driving on the freeway and my st started loosing power and as soon as i hit the clutch it just died. Had to get it towe...
either way is fine, as long as it has a refrence of manifold pressure.
some have the VSV, some do not....
^^^ Good answer. yep if you still have good compression and not burning oil, leave it alone. if you do want to rebuild then look at my thread for rebu...
hey guys i went in for a coolant flush a few days ago and before that it was warm out so i turned the heat dial to the cold part and my temp gauge wen...
any one know where the fuse for the washer jets are got the haynes manual but doesnt list or show it really needing some help...
4AGE has TONS more aftermarket parts....
between the two its not something that you would notice significantly....
and the vvti sensor, did u ask. If not its 225 plus shipping from japan....
bleed the clutch line...
+1 on broken clutch spring for me
it was wedged between the clutch and the flywheel not allowing the pedal to disengage the tranny from the motor
hope...
^^^ correct if the gasket is still soft then its fine. you only need to replace it when its hard and brittle...
So i need help about my problem...
the car is ST202 JDM GT with auto trany 1995 year 110 000 miles
When the car is hot (normal working temperature) .....
We've gone over this sooo many times! search for it! and that one is locked too!
If you want to spend the money, go for it, but it will be a sh!t ton ...
Just wondering in my free time, but would it be possible to swap in a longitudinal 3gr-fse or 1gr-fe, add the rear diff, etc. and make the celica a rw...
Here....right out of the good book.
Connect pos (+) lead from the battery to terminal +B and neg (-) to terminal ISCC, and check that the valve is clo...
^^^ got a point- but STOOOOPIDLY unlikely. not to be confused with impossible. We've all seen stranger.... lol
QUOTE (HectortheRican @ Mar 19, 2011 - ...
I've been browsing the forums for quite some time but haven't yet pinpointed the exact problem.
Warm and cold, my car will idle fine, but occasionally...
Horsepower TV did some testing with e3's and all their dyno test showed good results. I have a feeling that e3 payed them or sponsored them to do all ...
Hey guys my problem that my idle is idling higher after changing out distributor, first is was at 800-900 now after the change it is now at 1000rpm ne...
I have a 1994 st now with an automatic transmission, and I have a 95 st, with a manual transmission.
I was told by the guys at NTB that the passenger ...