Engine/Transmission/Maintenance
14,249
Total Topics
25
Showing
116
Page 116 of 570
Topics in Engine/Transmission/Maintenance •
newest topics first
Any 4age tranny will bolt up to the stock st mounts. If you have a choice try to pick up a 4agze tranny out of a 87-88 mr2, great ratios, strong synch...
I'm in the process of pulling the Beams out of the clip, but I can't find the rear hook to lift the engine.
Using the pic below (not my engine) I have...
After doing the swap the car runs but it wont idle right. it idles at 800rpms and it wont go faster then 60mph.
I been trying to get this fixed right ...
Hey all please could someone help me. i need to change the spark plugs on my gt4 but dont know what to do about the intercooler i.e antifreeze and bl...
As I have just learned this greatly impacts fuel economy. The ECU isn't getting the right reading of oxygen concentration, and is thus mis-regulating...
Fusible link needs to be replaced. any idea on how to do it? or does this HAVE to be done by a tech?...
Alright, O2 sensor it is. And I'll fix up the exhaust. Only question now is: Denso or Bosch?...
please delete!
This post has been edited by
brenton1919
: Mar 29, 2011 - 9:55 PM...
Does anyone know what the drive train loss is in our cars? I can find it all over the internet for the 7th gen, but not ours. Idk how safe it is to as...
^^ correct. Did you put some bearing grease on the "quil" or in other words the input shaft so it moves nice n easy?...
I got it off but can I just get a new clamp for the boot since it came off?...
10 X 1.25...
double check the ignition timing, what number is too high? HC?...
Follow your lower radiator hose to the engine....
add a 330 ohm resistor inline with the ecus coolant temp sensor. its the 2 wire CTS on the water neck kinda pointing towards the throttle body.
this w...
hey thanx Ive been looking for this link and couldnt find it! I jus found a huge piece of what I guess to be axle in the diff. wow no wonder It was ma...
hi ! my front cross member is broken cauze the rust just where the left tab is
, does someone know if the cross member of the gt-4 is the same as the ...
Here is my intake, i think it works gret and didn't have to spend tons extra to make it work (just 4 bucks for a 3 inch to 3 inch silicone adapter sin...
Does not having enough back pressue on an NA motor ( I.e. Mid pipe removed so exhaust exiting right out of the headers) burn up th valves?...
Good to read this, you can here my intake from my house when I start the car up and I thought something may have been acting up =p...
Any clutch kit will do really. Exedy is a reputable clutch company, but the basic clutch disk is organic theres nothing special about it at all. Just ...
add a 330 ohm resistor inline with the ecus coolant temp sensor. its the 2 wire CTS on the water neck kinda pointing towards the throttle body.
this w...
Bump for help, don't want to waste my money...
get a multimeter and test the primary and secondary leads on the coil, there should be a sticky link showing CEL codes. Find the page where it has the...