Engine/Transmission/Maintenance

14,249 Total Topics
25 Showing
107 Page 107 of 570
Topics in Engine/Transmission/Maintenance • newest topics first
5 posts • Started by 6G96GT
Hey guys, back with another question that I have been unable to find the answer to (normally that means whatever I want to know is common knowledge an...
2 posts • Started by njccmd2002
So i noticed that on cold starts ill get a bit of knocking that goes away as soon as the idle stabilizes, but will knock if i revv... now the weird th...
8 posts • Started by 6G96GT
15 seconds, these cars are slow, but i really dont know.....
7 posts • Started by H1gherReflex
bottom was easier for me...
15 posts • Started by 3WayStunna
4000 for a complete kit like that seems to be a pretty good deal....
4 posts • Started by Galcobar
does anyone does know how to change the oil gasket because my car is leaking a lot of oil...
12 posts • Started by 6G96GT
Alternately, get it from an online Toyota retailer, such as 1sttoyotaparts.com or www.lithiatoyotaparts.com, both of which are operated by Toyota deal...
12 posts • Started by 6G96GT
change your plugs....
12 posts • Started by bloodMoney
Alternatively, you could have the items delivered to a receiving service just south of the border, save the time and exorbitant cost of cross-border s...
7 posts • Started by black93hardtop
a new TO bearing is greased up and should stop spinning immeadiatly, a used one that grease has broken down and worn out so it spins more freely. that...
5 posts • Started by al94st
Does anyone use any sealant for the rocker cover gaskets? If so what type did you use?...
7 posts • Started by al94st
Hey everyone, I'm at a loss on what to do... so I bought a 3" downpipe from berk last year for my 3S-GTE swap. well there was a dirty wield on it and ...
20 posts • Started by 4-eyed-freek
? Your gunna have to elaborate on that for me. Everything I've read on it yesterday did not mention that....just the increase in compression, and th...
24 posts • Started by 4-eyed-freek
180k on mine, all original 94 gt. plan on driving her till the wheels fall off. Will prolly by another celica if I can find one cheap to do all my.....
7 posts • Started by 6G96GT
Hey Guys, it's been a rather long time since I've posted up here (prolly over a year), lots of life-changes and all but still have my celica. Recent f...
25 posts • Started by 6G96GT
145whp? i think thats generous :\...
12 posts • Started by brenton1919
Given your information is wrong, you evidently saw someone drop a tank from a car that wasn't a Celica. This post has been edited by Galcobar : Aug 7,...
8 posts • Started by 6GenCircleLghts
4, 6, 8, 10mm hoses...
3 posts • Started by MrD
Can u switch a 3s-ge engine with a 7a-fe engine Just wondering because the speed of my car is starting to get old and i dont want to give her up for n...
2 posts • Started by replica250
Hi everyone, looking to put turbo engine in my celica st202 with a 3sge motor, Want to l Keep it fwd, will the standard gearbox fit st185 engine; also...
2 posts • Started by Island_Racer
Where is the best place on the block to bolt up the bracket when u wanna put it on a h stand? This post has been edited by Island_Racer : Jul 21, 2011...
20 posts • Started by 6G96GT
how much are you losing?...
4 posts • Started by Mike
Hey guys, my tank isn't air tight as there is a small crack in the filler sleeve. I can't find out how to drain the damn tank unless I get into the fu...
5 posts • Started by freddy121389
A beams wont get you 200-250Whp easily. I say go turbo, but do it RIGHT, don't cheap out. You shouldn't need to run over 15lbs of boost for your goal,...
7 posts • Started by 99gt3sge
Both of the Gen 3 engines (3S-GTE and 3S-GE) use the same timing belt (13568-79105) the Gen 2 is different part number....